Concrete mixer Stirring or turning a little slow rotation is what the situation

Concrete mixer is a commonly used in large and small prefabricated pieces of loose plants, water conservancy, factories, wharves of industrial and civil engineering can be mixed hard dry, plastic, epidemic and a variety of high-efficiency mortar machines in the production process When the concrete mixer in the mixing shaft to stop rotating or turning a little slow is normal, if this situation first stop checking to see if there are three cases the following.

1, concrete mixer is not a serious overload?

If the stirring shaft of the concrete mixer exceeds the normal working load, the stirring shaft will rotate slowly. If the load is too large, the stirring shaft will stop or the stirring shaft will bend.

2, the concrete mixer blade or side vane and the cylinder wall between the body there is no large foreign body?

This will also cause the concrete mixer to stop the rotation of the stirring shaft or slow rotation. Mixing blade or side vane and the tank wall between the larger foreign body will also lead to stalled mixing shaft, was able to card foreign body, is due to concrete mixing blades or side vane and the tank wall gap is too large. Especially stone

3, concrete mixer motor drive belt there is no loosening of the situation?

Concrete mixer motor drive belt too loose can also cause the product of concrete mixing machine mixing shaft slow or stop turning, motor drive belt too loose, resulting in transmission of power shortage.

Solution:

1, the concrete mixer overload caused by Stirring Stopped, just adjust the amount of feed, discharge excess material, reduce the rotation axis of the load can be.

2, the side of the blade and the inner wall of the stuck material, the stirring shaft before the stop there will always be sharp and harsh friction sound, such a situation, the need to immediately stop the inspection, artificial removal of foreign matter, re-adjust the concrete mixer blade or side The gap between the blade and the inner wall of the tank, if necessary, can be washed under water first.

3, the concrete mixer motor drive belt is too loose, just shut down after the adjustment of the concrete mixer motor drive belt tension can be.